Loading ...
Loading ...
Loading ...
14 Owner’s Manual for Lawn Edger
Maintenance and Troubleshooting
Storage
NOTE: A yearly checkup or tune-up by an IASD is rec-
ommended for optimal performance.
Proceed as follows to put unit in storage for thirty days or
more:
1. Run the engine until it is out of fuel.
2. Change engine oil. See
Changing Engine Oil.
3. Remove spark plug from cylinder. Pour 1 oz (29.5
mL) oil into cylinder. Slowly pull recoil handle so oil
will protect cylinder. Install new spark plug in cylin-
der. Pull starter handle slowly a few times to distrib-
ute oil. Pull recoil slowly until resistance is felt to
close cylinder valves. Do not attach spark plug
wire.
4. Clean edger. Remove all dirt, leaves, debris,
grease, etc. from edger, including cylinder cooling
fans, recoil starter cover holes, under fuel tank, and
under muffler.
5. Inspect edger for damage. Have damaged parts
replaced if necessary.
6. Inspect hardware, and tighten any loose fasteners.
7. Store unit in building with good ventilation, away
from spark such as space heaters or pilot lights.
8. Cover edger with a breathable material. Do not use
plastic as moisture can collect underneath and
cause rusting.
(000143)
Explosion and Fire. Fuel and vapors are extremely
flammable and explosive. Store fuel in a well
ventilated area. Keep fire and spark away. Failure to
do so will result in death or serious injury.
DANGER
(000180)
DANGER
Explosion and Fire. Drain fuel in a well ventilated
area, into an approved container only after engine
has cooled. Failure to do so will result in death
or serious injury.
(000109)
WARNING
Risk of Fire. Verify machine has properly
cooled before installing cover and storing
machine. Hot surfaces could result in fire.
Loading ...
Loading ...
Loading ...