Loading ...
Loading ...
Loading ...
10 Owner’s Manual for Lawn Edger
Operation
Adjusting Blade Angle
Blade can be adjusted 15° from vertical in both directions
to provide a beveled cut. This cuts grass further away
from the sidewalk or driveway, reducing the need to edge
as often. Use the beveled edge at a deep depth to cut a
trench into ground.
Proceed as follows to adjust blade angle:
1. Stop engine and allow it to cool.
2. See
Figure 3-1. Disengage the index lever (A) and
move it to the desired notch (15°, 0°, or -15°).
Figure 3-1. Index Lever
3. Line up edger before starting the engine.
Adjusting Wheel Height for Curbs
Proceed as follows to adjust wheel height for edging
curbs:
1. Stop engine and allow it to cool.
2. See
Figure 3-2. Loosen front wheel knob (B).
Figure 3-2. Adjusting Wheel Height
3. Slide wheels to the right, enough to clear the curb
and balance the unit.
4. Securely tighten front wheel knob.
5. Use front wheel adjustment lever (C) to lower front
wheels enough to level unit.
6. Loosen rear wheel knob (D).
7. Lower right rear wheel enough to level unit.
8. Securely tighten rear wheel knob.
Slopes
• This unit can be used on slopes up to 15°. Continu-
ous use on slopes steeper than 15° could result in
engine damage.
• Avoid sudden turns or maneuvers.
011372
A
011370
B
C
D
(000460)
Personal injury. Use caution when operating unit over
uneven terrain or slopes. Failure to do so could result
in death, serious injury, equipment or property
damage.
WARNING
Loading ...
Loading ...
Loading ...