Loading ...
Loading ...
Loading ...
Installation
Page 8
Installation under Worktop
min595
min820
min600
Any installation may be carried out only by a qualitied
technician refer to section SAFETY.
Free Standing Installation
Install the appliance on solid ground. Adjust accurately all feet to
get a firm, horizontal position.
Only with a correct level the appliance door closes and seals correctly.
1.Optional:Remove the work top of the appliance.
2.Adjust accurately all feet to get a firm level position.
3.Stick the water-proof sticker on the bottom of the countertop.
4.Install the appliance carefully into the recess.
If used as free standing appliance again, the worktop
must be remounted.
5.The dimensions of the recess should at least agree with the dimensions
in the figure.
6.After installation, the minmum gap between the side planel and the
cupboard is 1mm, and the minmum gap between the rear and the
cupboard is 10mm. The top gap is controlled by adjusting the feet.
7.Put the appliance adjacent to the slot. Make sure that all connections
(water, drain water, power) are neatly positioned and connected.
FreshWater Connection
fig.A
>10mm
Do not shorten the inlet hose.
1. Take note of water connection requirements.
The dishwasher has a single valve water connection.
We recommend a cold water connection for best performance and energy efficiency.
The appliance should be connected to the water main using the new water inlet
hose supplied. Old hoses should not be used.
CAUTION！
Loading ...
Loading ...
Loading ...