Loading ...
Loading ...
Loading ...
Page 21
Using Your Dishwasher
Please note that not all sales models comes with
identical features and options. So pictures of that
chapter are sometimes different to your dishwasher
model. Explanations try only to point out basic
model variants.
1. Load the baskets.
2. Open the water tap.
3. Press the ON/OFF button to activate the
appliance.
If the rinse aid indicator is on, fill the rinse aid
dispenser and the rinse aid indicator; refer to section
HOW TO RESET THE RINSE AID INDICATOR.
4. Add the detergent; refer to section DETERGENT.
5. Close the door.
6. Set the programme according to the type of load
and how dirty the dishes, cups and cutlery are.
7. Maybe select a start delay time.
8. Press the START / PAUSE button to start
the programme.
9. After programme end close the water tap.
10. After programme end the appliance change to
auto off.
Start a Programme
1. Close the door.
2. Open the water tap.
3. Press the ON/OFF button .
4. Press sequentially the PROGRAMME SELECT
button and until the required programme
indicator lights up.
5. If desired select a start time for a delay start.
Refer to section START A PROGRAMME WITH
DELAY.
6. Press the START/PAUSE button to activate
the programme or the delay start.
The programme starts. The display acts now as
countdown of the remaining run-time.
The appliance remembers the last programme
you used. The next time the appliance will switch
on, the appliance pre-selects the programme last
used.
Set a start time by the following procedure in order
to delay a programmestart:
1.Set a programme.
2.Press sequentially or hold the button until the
display flashes the required delay time(form 1 to 24
hours).
3.Press the START/PAUSE button .
Interrupt a Running Programme
To interrupt a programme run:
Press the button . In the display is flashing.
and/or
Open the door.The displayed cycle time is
flashing.
Press the button and/or close the door to
continue the programme from the point of interruption.
Longer breaks may cause bad cleaning results.
Start a Programme with Delay
Standby Mode
The switched on appliance will go into standby mode if it is
not activated within 2 minutes before starting a programme,
or at the end of a programme. This saves energy. The display
switches off. To interrupt the standby mode push one button.
When the programme is completed, the display shows and
an accoustic signal is heard (if it is not switched off). The
display switches off.
1. Press to switch off the appliance or the appliance switches
into standby mode automatically after 2 minutes.
2. Open the door.
3. Remove dishes:
Let the dishes become cold before removing them from
the appliance.Hot dishes damage more easily.
First remove the items from the lower basket, then from
the upper basket.
If the door will be opened immediately after
the end of programme, hot steam can escape.
Danger of scalding! Open the door carefully!
End of Programme
Activate / De-Activate the Buzzer
An accoustic signal informs about the end of a programme.
This signal can be switched off.
Refer to section HOW TO ADJUST SETTINGS and select
the setting:
If the display shows the signal is switched off.
If the display shows the signal is switched on.
Refer to section HOW TO ADJUST SETTINGS and select
the setting:
If the display shows the signal is switched off.
If the display shows the signal is switched on.
Automatic door opening
After the wash the door will automatically open slightly to
assist with drying.
For best results, unload dishes once cooled.
This function can be switched off.
Cancel Start Delay / Programme
1.Press any other function button to cancel this function.
2. Start a new programme and a delayed start if desired.
Loading ...
Loading ...
Loading ...