Loading ...
Loading ...
Loading ...
Page 23
Care and Cleaning
How to keep your Dishwasher in shape
After every wash, turn off the water supply to the
appliance and leave the door slightly open so that
moisture and odours are not trapped inside.
Before cleaning or performing maintenance,
always remove the electrical plug from the socket.
To clean the exterior and rubber parts of the
dishwasher, do not use solvents or abrasive
cleaning products. Only use a cloth with warm
soapy water.
To remove spots or stains from the surface of the
interior, use a cloth dampened with water and a
little vinegar, or a cleaning product made
specifically for dishwashers.
When not in Use for a long time
It is recommend that you run a wash cycle with the
dishwasher empty and then remove the plug from the
socket, turn off the water supply and leave the door of
the appliance slightly open. This will help the door
seals to last longer and prevent odours from forming
within the appliance.
Moving the Appliance
If the appliance must be moved, try to keep it in the
vertical position. If absolutely necessary, it can be
positioned on its back.
Seals
One of the factors that cause odours to form in the
dishwasher is food that remains trapped in the seals.
Periodic cleaning with a damp sponge will prevent
this from occurring.
Protect against Freezing
Please take frost protection measures on the
dishwasher in winter. After washing cycles, please
operate as follows:
1. Turn off the electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water
inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve.
(Use a pan to catch the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a
sponge to soak up water in the sump.
NOTE: If your dishwasher
cannot work because of
the ice, please contact an authorised service person.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for
hard water chemicals will clog the spray arm jets and
bearings.
1. Turn screw fastening anticlockwise to removespray
arm.
2. Remove remaining parts of food remnants with a
thin pointed object.
3. Flush with water and check all the holes are clear.
4.Turn bayonet socket clockwise to fasten spray arm.
1. Pull vertically at the centre to remove spray arm.
2. Remove remaining parts of food remnants with a
thin pointed object.
3. Flush with water and check all the holes are clear.
4. Place spray arm at the centre with a light push.
Lower spray arm
Upper spray arm
Loading ...
Loading ...
Loading ...