Loading ...
Loading ...
Loading ...
UPPER THREADING
Getting Ready
47
1
b
Place the spool of thread on the spool pin so that the
thread feeds off the spool clockwise. Firmly insert the
spool cap onto the spool pin.
c
Pull the thread off the spool. Pass the thread from the
back to the front through the thread guides at the top.
When using thread that quickly feeds off the spool, such
as metallic thread, use the enclosed ring to prevent the
thread from becoming entangled.
Threading sequence; Pull the thread from the spool,
place the thread through the ring from the bottom up
(1), into the thread guide (2) and through the ring from
the top down (3). When using the ring, do not use the
spool cap base.
d
Pass the thread through the machine’s thread guide
from the right to the left.
1 Thread guide
e
Thread the machine according to the steps f to o of
“Upper Threading” on page 42.
Note
• When using two spools of thread, make sure that
both spools are feeding in the same direction.
• Make sure that the spools do not touch each other,
otherwise the thread will not feed off smoothly, the
needle may break, or the thread may break or
become tangled. In addition, make sure that the
spools do not touch the telescopic thread guide at
the center.
• Make sure that the thread is not caught under the
spool.
Note
• Guide the thread so that it does not become
entangled with the other thread.
• After feeding the thread as instructed, wind any
excess thread back onto the spool, otherwise the
excess thread will become tangled.
2
13
Loading ...
Loading ...
Loading ...