Loading ...
Loading ...
Loading ...
14
Enclosure Configuration
Combining (Baying) Enclosures
WARNING: Combining enclosures is not a substitute for stabilizing the enclosures. Each enclosure in a bay of
combined enclosures requires the same stabilizing measures as a standalone enclosure.
1
Arrange the enclosures in the correct position for baying.
2
Each enclosure includes 4 baying brackets
A
that correspond to
baying connection points
B
on the adjoining enclosure. The baying
connection points already contain screws. Remove the screw from
each baying connection point in the adjoining enclosure.
3
Loosen the screw in each baying bracket and turn each bracket
90 degrees toward the adjoining enclosure, aligning each bracket
with the corresponding baying connection point on the adjoining
enclosure.
4
Connect each bracket to the adjoining enclosure using the screws
you removed in step 2, but do not tighten the screws completely.
Adjust the position of the enclosures as needed. If you want the
centers of the enclosures to be 24 inches/61 cm apart (29.9 in./76
cm for the SR42UBWD), use the outside hole of the bracket
C
. If
you want the centers to be 23.6 inches/60 cm apart (29.5 in./75 cm
for the SR42UBWD), use the middle hole of the bracket
D
. After
connecting all brackets and conrming that the enclosures do not
need further adjustment, tighten all screws.
Note: You may wish to remove the doors from the enclosures before
combining them. Reinstalling the doors afterward is optional. Remove the
interior side panels before baying enclosures if you wish to enable access
between enclosures.
90°
1
2
3
4
A
B
C D
Loading ...
Loading ...
Loading ...