Loading ...
Loading ...
Loading ...
13
Enclosure Configuration
1
2
3
Adjusting Mounting Rails and Cable Management Rails
WARNING: Do not attempt to adjust rails without assistance. Do not attempt to adjust rails while equipment is
installed in the enclosure. Do not attempt to use rails without screws installed (6 per rail).
The 4 mounting rails are pre-installed to accommodate equipment with a mounting depth of 30 inches (762 mm). Do not
adjust the mounting rails unless your equipment requires a dierent mounting depth. The front and rear sets of rails can
be adjusted independently in ¼-inch (6 mm) increments for mounting depths between 4 inches (101.6 mm) and 42 inches
(1066.8 mm).
1
Each rail is connected to the enclosure with 4 screws -
1 pair at the upper beam
A
, and 1 pair at the lower beam
B
.
2
Remove the screws fastening each of the rear mounting rails to the
enclosure. (If adjustment of the front rails is required, you can also
remove the screws from the front rails.)
3
Slide the mounting rails to the desired depth and reattach them
using the screws you removed in Step 2. The rail attachment points
are numbered
A
to help you align each pair of rails at the same
depth.
The depth of the 2 cable management rails can be adjusted
using the same method.
B
A
A
Loading ...
Loading ...
Loading ...