Kenmore 625348320 Official Water Softener

User Manual - Page 19

For 625348320.

PDF File Manual, 36 pages, Download pdf file

Loading ...
Loading ...
Loading ...
SECTION 4 OTHERTH,NGSTOKNOW
i j
4A. HOW TO "FINE-TUNE" YOUR SOFTENER
c. Press the RECHARGE DAY button [] and
SUnday begins to flash.
-- If you z_,al_l regenerations on Sunday (from
regeneration table), press the SET/CLEAR button
[] to display ON.
-- If you do l_ot wal_l Sunday regenerations, press
SET/CLEAR button [] to display OFF.
do
Press the RECHARGE DAY button [] again to
display a flashing MOnday and ON (factory set
recharge). As you did in step c, use the SET/
CLEARbutton [] to change the display from
ON to OFF, or from OFF to ON.
eo
Press RECHARGE DAY button [] to display a
flashing TUesday, WEdnesday, etc., each time
using the SET/CLEAR button [] to display ei-
ther ON or OFF as needed.
After recharge is either set or cancelled for SAt-
urday, press the PRESENT TIME AND DAY
button [] once again to return the present
time and day display.
2. SET THE FILL CYCLE MINUTES
ao
bo
Press and hold the RECHARGE TIME button
[] until FILLshows in the display, then release
button []. After a few seconds, the fill cycle
minutes (factory setting... 16) will flash.
Press the SET/CLEAR button [] to set the min-
utes of fill cycle needed, as shown in the re-
generation table.
NOTE:
You may get hard water between regenerations if
you set the timer for fewer fill minutes than the
Regeneration Table shows you to set. A higher
setting than needed will waste salt.
NOTE:
Press SET/CLEAR and quickly release to move the
display ahead 1 minute at a time. Or, hold the
SET/CLEAR button to move the display ahead 2
minutes each second. THE DISPLAY BEGINS
OVER AT 0 AFTER PASSING 59.
c. Press PRESENT TIME AND DAY button [] to
return the present time and day display.
TO SET THE PRESENT TIME OF DAY, AND DAY
OF WEEK, SEE PAGE 6.
IF YOU NEED HELP TO PROGRAM THE TIMER, CALL TOLL FREE,
NUMBER 1-800- 426-9345.
19
Loading ...
Loading ...
Loading ...