Loading ...
Loading ...
Loading ...
SECTION 3 CARE OF YOUR SOFTENER
3C. KEEP THE SOFTENER FROM FREEZING
If the softener is installed where it could freeze
(summer cabin, lake home, etc.), you rnust drain
all water from it to stop possible freeze damage.
To drain the softener-
1. Close the shut-off valve on the house main
water pipe, near the water meter or pressure
tank.
2. Open a faucet in the soft water pipes to vent
pressure in the softener.
.
I.ooking at FIG. 16 on [)age 21, move the stem
in a single bypass valve to bypass. Close the
inlet and outlet valve in a 3-valve bypass
system, and open the bypass valve. Ifyou want
water in the house pipes again, reopen the
shut-off valve on the main water pipe.
4. Unplug the transformer at the wall outlet.
Remove the salt hole cover and the main
cover. Take off"both drain hoses.
.
Carefully remove the large holding clips at the
softener inlet and outlet (see Key No. 61, on
page 34). Separate the softener from the
adaptors or bypass valve.
° Remove the brinewen cover and disconnect
the brine valve tubing at the nozzle and venturi
assembly (see page 34). Liftthe brine valve out
of the brinewell. Tip the brine valve upside
down to drain out water.
DRAIN WATER FROM THE
SOFTENER
Drain Wood Block
.
°
Looking at FIG. 14, lay a piece of 2 inch thick
board near the floor drain. Move the softener
close to the drain. SLOWIX and CAREFULIX
tip it over until the rim rests on the wood block
with the inlet and outlet over the drain. Do not
allow the softener's weight to rest on the
inlet and outlet fittings or they will break.
Tip the bottom of the softener up a few inches
and hold until all water has drained. Leave the
softener laying like this until you are ready to
use it. Plug the inlet and outlet with rags to
keep dilx, bugs, etc. out.
16
Loading ...
Loading ...
Loading ...