Loading ...
Loading ...
Loading ...
Motor Specifications and Electrical Requirements ..............
General Electrical Connections
DANGER: To avoid electrocution:
1. Use only identical replacement parts when ser-
vicing. Servicing should be performed by a
qualified service technician.
2. Do not use in rain or where floor is wet.
This too] is intended for indoor residential use
only.
WARNING Do not permit fingers to touch the ter-
minals of plug when installing or removing the
plug to or from the outlet.
If power cord is worn or cut, or damaged in any way,
have it replaced immediately-
I!,ln . "1 Ul I,, I I
Power Supply and Motor Specifications
WARNING: To avoid electrical hazards, fire haz-
ards or damage to the tool, use proper circuit pro-
tection. Your tool is wired at the factory for
operation using the voltage shown. Connect tool
to a power line with the appropriate voltage and a
15-amp branch circuit. To avoid shock or fire, if
power cord is worn or cut, or damaged in any way,
have it replaced immediately.
The A-C motor used on this tool is a relay start, having the
following specifications: ',It is wired at the factory for opera-
tion on 11Oq20V AC. 60 Hz. operation.
1/3 JJ_Z (Cycles) 6
110-120 _e
Counterclockwise
110-120 V01t, 60 Hz. Tool information
NOTE: The plug supplied on your tool may not fit into the
outlet you are planning to use, Your local electrical code
may require slightly different power cord plug connec-
tions. If these differences exist refer to and make the
proper adjustments per your local code before your tool
is plugged in and turned on.
In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped
with an electric cord having an equipment grounding con-
ductor and a grounding plug, as shown, The plug must
be plugged into a matching outlet that is properly
installed and grounded in accordance w_th all local codes
and ordinances.
Do not modify the plug provided. If it will not fit the outlet,
have the proper outlet installed by a qualified electrician.
A temporary adapter may be used to connect this plug to
a 2-pole outlet, as shown, if a properly grounded outlet is
not available. This temporary adapter should be used
only until a properly grounded outlet can be installed by a
qualified electrician, The green colored rigid ear, lug and
the like, extension from the adapter must be connected to
a permanent ground such as a properly grounded outlet
box.
Improper connection of the equipment grounding con-
ductor could result in a risk of electric shock. The conduc-
tor with insulation having an outer surface that is green
with or without yellow stripes is the equipment grounding
conductor. If repair or replacement of the electric cord or
plug is necessary, do not connect the equipment_g round-
ing conductor to a live terminal
If the grounding instructions are not completely under-
stood, or if you are in doubt as to whether the Iool is prop-
erly grounded check with a qualified electrician or service
personnel.
WARNING: if no_ properly grounded, this tool can
cause an electrical shock, particularly when used
in damp locations, in proximity to plumbing, or out
of doors. If an electrical shock occurs there is the
potential of a secondary hazard, such as your
hands contacting the sanding drum.
Properly
Grounded
Outlet _,
3-Prong Plug
Grounding
Prong
Green I
Grounding Lug !(_-_
3-Prong _:_1
P,ug
Adapter
Make sure this
is Connected
to a Known
Ground
NOTE: The adapter illustrated is for use only if you have a
properly grounded 2-pro,qg outlet,
Loading ...
Loading ...
Loading ...