Loading ...
Loading ...
Loading ...
After using stair/upholstery nozzle
Disconnect deep cleaner from electrical outlet.
Follow the instructions for "After cleaning" on page 9.
Drain suction hose by turning deep Gleaner on and holding
nozzle up for several minutes. DO not press trigger.
Disconnect cleaner from electrical outlet.
Disconnect hose and solution tube from deep Gleaner.
I
Drain solution tube by placing round end in sink, and raising
nozzle above your head. Press the trigger.
CONVERTER
CLIP
Occasionally, debris may become lodged inside of the hose at
the converter end.
To clean-out the hose, lift bottom of converter clip with a screw
driver and remove clip. Remove debris as shown.
SOLUTION
HOSE
Snap clip back into positon making sure solution hose is not
pinched and moves freely.
Replace recovery tank front panel. Slide panel down until it
snaps firmly in place.
12 Stair/upholstery nozzle -Cleaning carpeted stairs
Read "Before you begin cleaning" instructions on page 8.
Attach hose and solution tube as instructed on page 11
Fill clean solution tank according to instructions on pages 6 and
7. Use 5 ounces of HOOVER Carpet/Upholstery Detergent.
Hose length may require that machine be placed at the top of
the stairs to clean upper half of stairway and at bottom of stairs
to clean lower half.
To prevent machine from falling, use extra caution when
cleaning on stairs. Do not place deep cleaner on stairs.
Do not point stair/upholstery nozzle at people or pets.
Dry hands and plug deep cleaner into a properly grounded
outlet.
Turn deep cleaner ON.
Pre-spray the carpeted stair by holding the nozzle about one
inch above the carpet and push the wand forward while
pressing the solution trigger (equals one wet stroke).
i
Position nozzle against the riser and slightly press nozzle into
carpet pile. Press the solution trigger and pull the nozzle
slowly over the carpet (second wet stroke).
Release the trigger, lift nozzle, and position it against riser.
Pull nozzle slowly over carpet without pressing trigger (dry
stroke).
It is best to alternate wet and dry strokes as described above.
End with more dry strokes to aid in faster drying of carpet.
Overlap strokes by one-half inch to help prevent streaking.
To avoid saturating carpet, do not use more than 4 wet
strokes over any one area. Always end with dry strokes.
If additional cleaning is necessary, wait until the carpet is
completely dry before using the nozzle again.
When finished cleaning, follow "After cleaning" instructions on
page 9 and "After using stair/upholstery nozzle" instructions on
page 12.
Loading ...
Loading ...