Loading ...
Loading ...
Loading ...
Some models come with the bare floor attachment. For others,
the tool is available at additional cost from your Authorized
Hoover Dealer (Depot) or a Hoover Factory Service Center.
How to attach bare floor attachment
Disconnect deep cleaner from electrical outlet.
TANK
To prevent possible leaking, remove clean solution tank by
pressing down on tank handle and pulling forward; set tank
aside (do not set tank on furniture.)
HANDLE
RELEASE
PEDAL
LATCH
Step on handle release pedal and lower handle until it rests on
the floor.
Rotate recovery tank latches (one on each side of tank)
outward; lift tank off machine.
FOAM
STRIP
With handle in upright position, tilt deep cleaner back so that
handle rests on floor.
Place attachment on front of nozzle with foam strip (under
netting) in position as shown.
10 Cleaning bare floors
Push attachment against nozzle while rotating attachment
downward until both ends "snap" into place.
(Note: Some force may be required to rotate and snap
attachment into place.)
Return deep Gleaner to upright position.
Lower handle and replace recovery tank. Press down to ensure
that it is properly seated in place.
Rotate latches (one on each side of tank) inward to lock
tank in place. Raise handle to upright position.
To clean floor
Read "Before you begin cleaning" instructions on page 8.
Do not use the 'SteamVac' deep cleaner on hardwood floors.
Fill clean solution tank according to instructions on pages 6 and
7. Use 5 ounces of HOOVER Bare Floor Cleaner.
Do not use any type of wax with your 'Steamvac' deep
cleaner.
Dry hands and plug deep cleaner into a properly grounded
outlet,
Step on handle release pedal and lower handle to operating
position; turn deep cleaner ON.
Torelease solution, press trigger. Slowly move deep cleaner
forward and backward over area to be cleaned.
To pick up dirty solution, release trigger and slowly move deep
Gleaner over area where solution hasjust been dispersed. Use
both forward and reverse strokes.
When finished cleaning, follow "After cleaning" instructions on
page 9.
Remove attachment from nozzle and rinse in clear water. DO not
remove plastic screen or foam from attachment.
Loading ...
Loading ...
Loading ...