Loading ...
Loading ...
Loading ...
14
3. Re-connect the following:-
Gas supply tube to pilot burner.
Tighten gas supply tube at gas control end.
Refit piezo igniter.
Re-connect lead to piezo igniter.
1. Set burner low fire adjustment. Low fire screw
should be screwed fully 'In', then unscrewed by
measurement shown in ‘Gas Specifications’
table at end of this section.
NOTE:
‘Low Fire Screw’ should be sealed with coloured
paint on completion of low fire adjustment.
2. Refit control panel.
3. Refit gas control knob.
NOTE:
These conversions should only be carried out
by qualified service persons. All connections
must be checked for leaks before
re-commissioning the appliance.
For all relevant gas specifications refer to the
table at the end of this section.
1. Remove the following:-
Gas control knobs.
Control Panel.
Disconnect electrical connection lead from
rear of piezo igniters.
2. Remove main burner injectors and replace with
correct size injectors as shown in ‘Gas
Specifications Tables’ at rear of this section.
1. Carry out the following:-
Lead to piezo igniter.
Unscrew and remove piezo igniter.
Slacken gas supply tube at gas control end.
Disconnect gas supply tube to pilot burner.
2. Remove pilot injectors and replace with correct
size injectors as shown in ‘Gas Specifications
Tables’ at rear of this section.
Wing Nut
Main Burner Injector
Thermocouple
Connection
Pilot Securing Screws
Pilot Gas Supply Tube
Low Fire Adjustment Screw
Loading ...
Loading ...
Loading ...