Loading ...
Loading ...
Loading ...
ENGLISH
9
PRODUCT USAGE
Your Stand Mixer is adjusted at the factory
so that the flat beater just clears the
bottom of the bowl. If for any reason the
flat beater strikes the bottom of the bowl
or is too far away from the bowl, clearance
can be corrected as follows:
Tilt head
1. Lift motor head.
2. Turn screw (A) slightly to the left to raise
flat beater and to the right to lower flat
beater.
3. Make adjustment with flat beater, so it
just clears surface of bowl.
Bowl lift
1. Place bowl lift
handle in down
position.
2. Turn screw (B)
slightly to the
left to raise
flat beater and to the right to lower flat
beater.
3. Make adjustments with flat beater,
so it just clears surface of bowl.
NOTE: Flat beater must not strike on
bottom or side of bowl when properly
adjusted. If beater or wire whip is
adjusted too close so that it strikes
bottom of bowl, coating may wear off of
beater or wires may wear through on wire
whip.
Scraping sides of bowl may be necessary
under certain conditions regardless of
beater adjustment. Stand Mixer must be
stopped to scrape bowl or damage to
Stand Mixer may occur.
BEATER TO BOWL CLEARANCE
A
B
To attach Pouring Shield*:
1. Turn speed control to “0” (Off).
2. Unplug Stand Mixer or disconnect power.
3. Attach Flat Beater, Wire Whip, Dough
Hook or Flex Edge Beater* and Bowl.
Front the front
of the mixer,
slide the
Pouring Shield*
over the bowl
until it is
centered.
4. The bottom rim of the pouring shield*
should fit within the bowl.
W11371189A.indd 9 6/6/2019 6:34:04 PM
Loading ...
Loading ...
Loading ...