Loading ...
Loading ...
Loading ...
ENGLISH
7
PRODUCT USAGE
ASSEMBLING/DISASSEMBLING YOUR TILT HEAD STAND MIXER
To attach bowl:
1. Turn speed control to 0 (off).
2. Tilt motor head back.
3. Place bowl on bowl clamping plate.
4. Turn bowl gently in clockwise direction
(see illustration above).
5. Place the pouring shield on bowl.*
To remove bowl:
1. Turn speed control to 0 (off).
2. Tilt motor head back.
3. Turn bowl in counterclockwise direction.
To attach Flat Beater, Wire Whip, Dough
Hook or Flex Edge Beater*:
1. Turn speed control to 0 (off) and
unplug.
2. Raise motor head.
3. Slip beater onto beater shaft and press
upward as far as possible.
4. Turn beater to right, hooking beater
over pin on shaft.
To remove Flat Beater, Wire Whip, Dough
Hook or Flex Edge Beater*:
1. Turn speed control to 0 (off) and
unplug.
2. Raise motor head.
3. Press beater upward as far as possible
and turn left.
4. Pull beater from beater shaft.
To lock motor head in raised position:
1. Push locking lever up into unlock
position and hold.
2. Tilt motor head back.
3. Move locking lever into lock position.
To lock motor head in operating position:
1. Turn speed control to 0 (off) and
unplug.
2. Unlock the motor head and move it
down.
3. Lock the head to keep it down
4. Before mixing, test lock by attempting
to raise the motor head.
NOTE: Motor head should always
be kept in lock position when using Stand
Mixer.
To operate speed control:
1. Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher
speed to avoid splashing ingredients
out of bowl. See “Speed control
guide.”
Ki
t
c
hen
A
i
d
St.J
os
e
p
h
,
M
i
ch
i
g
a
n
,
U
S
A
1
2 4 6
8
10
OFF
ON
*Included with select models only. Also available as an optional accessory.
W11371189A.indd 7 6/6/2019 6:34:03 PM
Loading ...
Loading ...
Loading ...