Loading ...
Loading ...
Loading ...
26E
TROUBLESHOOTING
OPERATION
PROBLEM POSSIBLE CAUSE SOLUTION
The oven display does not
illuminate
Turn off power at the main power supply (fuse or breaker
box). Turn breaker back on. If condition persists, call an
authorized service center.
Cooling fan continues to run
after oven is turned off
The oven components have not
cooled sufciently
The fan turns off automatically when the electronic compo-
nents have cooled sufciently.
Oven door is locked and will
not release, even after cooling
Turn the oven off at the circuit breaker and wait a few
seconds. Turn breaker back on. The oven should reset itself
and will be operable.
Oven is not heating No power going to the oven Turn on power at the main power supply (fuse or circuit
breaker box). If condition persists, call a qualied electrician.
Oven Mode or Temperature not
selected
Press cooking option on keypad to select the oven mode
and temperature.
Oven is not cooking evenly Oven rack is not in correct position Refer to cook charts starting on page 18 for recommended
rack position.
Convection Bake Mode Always reduce recipe temperature by 25°F when baking
with Convection Bake mode.
Oven light is not working
properly
Light bulb is loose or burned out Replace or reinsert the light bulb if loose or defective. Touch-
ing the bulb with ngers may cause the bulb to burn out.
Oven light stays on Oven door does not close
completely
Check for obstruction in oven door. Check to see if hinge is
bent or door switch is broken.
Cannot remove lens cover on
light
Lens cover is dirty There may be a soil build-up around the lens cover. Wipe
lens cover area with a clean dry towel prior to attempting
to remove the lens cover.
Oven will not Self- Clean
properly
Oven was still warm when
Cleaning mode was selected
Allow the oven to cool before running Self-Clean cycle.
Oven is heavily soiled Always wipe out loose soils or heavy spillover before run-
ning Self-Clean cycle. See OVEN PARTS/CLEANING
METHODS on page 22.
If oven is badly soiled, set oven for a 4-hour Self-Clean cycle.
Clock and timer are not
working properly
No power going to the oven Turn on power at the main power supply. If the problem
persists, call an authorized service center.
Clock or Timer not set correctly See KITCHEN TIMER or DISPLAY SETTINGS on page
16.
Excessive moisture Oven was not properly preheated When using bake mode, preheat the oven rst. Convection
Bake and Convection Roast will eliminate any moisture in
oven (one of the advantages of convection).
Porcelain chips Oven racks removed and
replaced incorrectly
When oven racks are removed and replaced, always tilt
racks upward and do not force them to avoid chipping the
porcelain.
Loading ...
Loading ...
Loading ...