Loading ...
Loading ...
Loading ...
Installationoftherange.
Read theseinstructionscompletely and carefully.
Dimensionsand Clearances
Provide adequate clearances between the range and adjacent combustible surfaces.
25_1/2"_
fromwail
tofront of
panel
Minimum to 30"
cabinetson
eitherside 18" Minimum
ot range __
36"
C
_.inimum towail on
either sideof range
aBuve Jb [leiyllL
Maximumdepth
40W"
_Depthincluding handle: 25-9/16."
Depth to front of control knobs: 26-I/8."
0" clearance below cooking top and at rear ofrange
Models A B C
20" Wide 20" 203/s" 2"
24" Wide 24" 243/a" 0"
24
Important Safety Instructions
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code,ANSI Z223.1,latest
edition. In Canada, installation must conform
with the current Natural GasInstallation Code,
CAN/CGA-B 149.1or the current Propane
Installation Code, CAN/CGA-B149.2,and with
local codes where applicable.
This range has been design-certified bythe
American GasAssociation according to ANSI
Z21.1,latest edition and Canadian Gas
Association according to CAN/CGA-1.1latest
edition. As with any appliance using gas and
generating heat, there are certain safety
precautions you should follow. Youwill find
these precautions in the Important Safety
Instructions in the front of this guide. Read them
carefully.
• A range should NOTbe installed directly over
ldtchen cmpefing unless an insulating pad of
1/4-inch thick piece of pl}_vood is placed
between tile range and cmpet.
• Be sure )_)ur range isproperly installed by a
qualified installer or set_ice technidan.
• This range nmst be electrically grounded in
accordance with local codes, or in their
absence, with the National Electrical Code
ANSI/NFPA No. 70, lamst edition and
Canadian Gas Assodadon according to
CAN/CGA-1.1 latest edition. See Electrical
Connection Infi)rmation.
•Betore installing the range in an area covered
xdth linoleum or any other synthetic floor
o)vering, make sure the floor o wering can
withstand heat at least 90 °F. ab_)veroom
temperature without shrinking, warping or
discoloring.
• Make sure tile wall coverings around tlle range
can _dthstand tile heat generated by the range.
• Make sure all conuols ieF[lain ill the OFF
position when tile T_lngeis not in use.
Loading ...
Loading ...
Loading ...