Loading ...
Loading ...
Loading ...
INSTALLATION GUIDE
UNPACKING YOUR DRAWER MICROWAVE
• Remove all packing materials from inside the
Drawer Microwave. DO NOT REMOVE THE WAVE-
GUIDE COVER, which is located on the top of the
appliance.
• Remove the feature sticker, if there is one. Check the
drawer for any damage, such as misaligned or bent
drawer, damaged drawer seals and sealing surfaces,
broken or loose
drawer guides and dents inside the cavity or on the front
side of the drawer. If there is any damage, do not operate
the appliance and contact your AUTHORIZED SERVICER.
IMPORTANT NOTES TO THE INSTALLER
• Read all of the Installation Manual before installing the
Drawer Microwave.
• Remove all packing material before connecting the
electrical supply.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
IMPORTANT NOTES TO THE CONSUMER
Keep this manual with your Use and Care Manual for
future reference.
• As when using any microwave oven generating heat,
there are certain safety precautions you should follow.
These are listed in the Use and Care Manual. Read all and
follow carefully.
• Be sure your Drawer Microwave Oven is installed and
grounded properly by a qualified installer or service
technician.
CLEARANCES AND DIMENSIONS
• Dimensions that are shown in figure 1 must be used.
Given dimensions provide minimum clearance. Locate
electrical outlet in the shaded area in the upper left-hand
corner of the cutout. See figure 4.
• Contact surface must be solid and level. Pay special
attention to the floor on which the appliance will sit. The
floor of the opening should be constructed of plywood
strong enough to support the weight of the oven (about
100 pounds).
• Check location where the Drawer Microwave will be
installed for proper electrical supply.
• Your appliance can be built into a cabinet or wall by
itself or under a gas or electric wall oven.
• Be sure that the clearance of the floor between the wall
oven and the Drawer Microwave is a minimum of 2".
• The microwave interior will easily accommodate a 9" x
13" oblong dish or a bag of microwave popcorn.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event
of an electrical short circuit, grounding reduces
the risk of electric shock by providing an escape
wire for the electric current. The Drawer
Microwave is equipped with a cord having a
grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly
installed and grounded in accordance with the
National Electrical Code and local codes and
ordinances.
WARNING: Improper use of the grounding plug
can result in a risk of electric shock. Do not
use an extension cord. If the power supply
cord is too short, have a qualified electrician
or serviceman install an outlet near the
appliance.
21
Loading ...
Loading ...
Loading ...