Loading ...
Loading ...
Loading ...
17
Exterior
Cleaning
The doorand cabinet may be cleaned with a mild detergentand warm water solution such as 28g of
dish washing liquid mixed with 7.5L of warm water. Do not use solvent-based or abrasive cleaners. Use
a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting.
Stainless steel models can discolor when exposed to chlorine gas and should be cleaned. Clean
stainless steel models with a mild detergentand warm water solution and a damp cloth. Never use
abrasive cleaning agents.
NOTICE:
Stainless
steel
models
exposed
to
chlorine
gas
and
moisture,
such
as
in
areas
with spas or swimming pools, may have some discoloration of stainless steel.
Discoloration from chlorine gas is normal.
Interior Cleaning
For Ice Storage Bin
The ice storage bin should be sanitized occasionally. Clean the bin before the ice maker is used for the
first time and reused after stopping for an extended period of time. It is usually convenient to sanitize
the bin after the ice making system has been cleaned,and the storage bin is empty.
1. Disconnect power to the unit.
2. Open the doorandwith a clean cloth, wipe down the interior with a sanitizing solution made of
28g of household bleach or chlorine and 7.5L of hot water (95℉to 114.8℉
℉
).
3. Rinse thoroughly with clear water. The waste water will be drained out through the drain pipe.
4. Reconnect power to the unit.
The ice scoop should be washed regularly. Wash it just like any other food container.
Ice
Making
Parts
Cleaning
During the using, periodically to clean these main system of your ice-maker.
1、Repeat above step to clean the water tankand other innerparts of the unit.
2、Especially, to the water dividing pipe on the evaporator, when the compressor and the water pump
run normally, but if there is no water flowing out from the water dividing pipe or the water flowing is
very small, please discharge this water dividing pipe to clean carefully. Cleaneach little holes on
the water dividing pipe displayed in the following illustration, make sure each hole is not clogged by
something, then install back to the original location.
3、When there are ice cubes on the surface of the evaporator, but can’t fall down easily, do not use the
mechanical substance to remove it by force; Only press the “ON/FF” button for more than 5
seconds, the unit willenter the ice melting process, after some while, the big ice-cubes will fall
down, then turn off the unit andunplug the power cord to clean the surface of the evaporator.
Loading ...
Loading ...
Loading ...