Loading ...
Loading ...
Loading ...
13
3. Connect the water hose to the water faucet of the water main supply system
First, install the supplied water quick-connector to the water faucet by screw thread; Second,
remove the clipper from the water quick-connector, insert the another end of the water hose into
this quick-connector port completely, then install back the clipper, also this step is completed.
Note: The water faucet should be supplied by the customer himself.
Important: The water pressure of main water supply system must be 0.04-0.6MPa .
OPERATION YOUR UNIT
Operation the ice-making process
1. After all of the water pipe connecting is completed, plug on the main power supply plug. Then press
“ON/OFF” button on the control panel to begin the ice making cycle，and the“ICE”light will be on
at same time.
The digit window will display the ambient temperature normally. And when the digit change to flash,
it means the left time to complete one ice making cycle. The compressor, fan motor and water pump
will run during ice making process.
2. Each ice making cycle will last about 11 to 20 minutes, depending on the ambient temperature and
the water temperature. And for the first time, according to the initial water temperature, ice-making
last time will be a little longer.
3. When the ice-making process is over, then switch to ice-harvest process. During the ice-harvest
process, the“ICE”light will flashes, and the compressor will still run. At same time the system will
detect the water level, if the water level is lower than the setting position, “ADD WATER”light start
to flashes, open the water inlet electro-magnetic vale to supply the water to water tank, and the
floating ball of the water level detecting switch in the tank will raise up, till the water level is higher
than the setting position, the water supplying process finish, and the “ADD WATER”light is off
again.
When the ice-harvest finish, the Ice-full detecting plate will rotate downward once, then recover to
the original position and enter to the next ice-making process.
If after the rotation of the Ice-full detecting plate, it is pressed by the ice cube and can’t recover to
the original position, means the the unit is full of the ice cube and it will stop making the ice
automatically.
4. When the “Full ” indicator is on, the unit stops running. And if you move away the ice cube, the unit
Loading ...
Loading ...
Loading ...