Loading ...
Loading ...
Loading ...
iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 48
Set Line Crossing Detection
Detects objects crossing a pre-defined virtual line. If it occurs, the device can take linkage actions.
Steps
1. Go to Configuration → Event → Smart Event → Line Crossing Detection.
2. Check Enable.
3. Select one Line and set the size filter. For the size filter settings, refer to Set Size Filter.
4. Click Draw Area and a line with an arrow appears in the live video. Drag the line to the location on the
live video as desired.
5. Set rules.
• Direction: The direction from which an object goes across the line.
• A<->B: An object going across the line from both directions can be detected and alarms are
triggered.
• A->B: Only n object crossing the configured line from the A side to the B side will be detected.
• B->A: Only an object crossing the configured line from the B side to the A side will be detected.
• Sensitivity: Percentage of body part of an acceptable target that crosses the pre-defined line.
Sensitivity = 100 - S1/ST × 100. S1 is the target body part that crosses the pre-defined line. ST is the
complete target body. The higher the sensitivity value, the more easily the alarm is triggered.
• Object: Specify the object type to be detected and the device will detect only that object type.
Figure 6-5 Set Rule
6. Optional: You can set the parameters of multiple areas by repeating the above steps.
7. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings, refer
to Linkage Method Settings.
Loading ...
Loading ...
Loading ...