Loading ...
Loading ...
Loading ...
9
3. Press the button (B2): the corresponding Led
lights up;
4. Press the Espresso button (B7);
5. Preparation begins and the Led corresponding to the Es-
presso button blinks on the control panel (B).
8.3
Making coee using pre-ground coee
Important!
• Never add pre-ground coee when the machine is o, or
it could spread through and soil the inside of the machine.
This could damage the machine.
• Never use more than 1 level
measure (D2), as this could soil
the inside of the machine or
block the funnel (A3).
Please note:
When using pre-ground coee, only one cup can be made at
a time.
1. Press (B3): the corresponding Led lights up;
2. Make sure the funnel is not blocked, then add one level
measure of pre-ground coee (g. 16).
16
3. Place a cup under the coee spouts (A17) (g. 15);
4. Select the required drink (B7);
5. Preparation begins and the Led corresponding to the se-
lection blinks on the control panel (B).
8.4 General indications for making coee-
based drinks
• Indicator lights may appear on the control panel (B) dur-
ing use. Their meaning is given in section “17. Explanation
of lights”.
• For hotter coee, see section “8.7 Tips for a hotter coee”.
• If the coee is delivered a drop at a time, too weak and
not creamy enough or too cold, read the tips in section
“18. Troubleshooting”.
• To customise the drinks according to personal taste, see
sections “8.5 Varying the intensity of the coee” and “8.9
Customising the quantity in the cup”.
Please note:
In energy saving mode, a few seconds may elapse before the
rst coee is delivered as the appliance must heat up again.
8.5 Varying the
intensity of the coee
1. Press the button (B4)corresponding to the preferred
intensity:
Mild
Medium
Strong
2. Select the desired coee drink.
Please note:
• When the next coee is made, the machine will show the
last intensity setting selected.
• In the event of power failure, the machine will revert to
the default setting: medium.
8.6 Rinsing
Using this function, hot water can be delivered from the coee
spouts to clean and heat the internal circuit of the machine.
1. Place a container of at least 100ml capacity under the cof-
fee spouts (A17) (g. 5).
2. Press the
button
(B6) and hold for at least 5 seconds:
the cycle will start and stop automatically (to terminate
the cycle sooner, press this same button a second time).
Please note:
• If the appliance is not used for more than 3-4 days it is
highly advisable, when switching on again, to run 2/3
rinse cycles before preparing any drinks;
• It is normal for the grounds container (A10) to contain
water following a rinse cycle.
8.7 Tips for a hotter coee
To make a hotter coee, proceed as follows:
• run a rinse cycle (see section “8.6 Rinsing
”);
• warm the cups with hot water, using the Hot Water
function;
• increase the coee temperature (see section “12. Settings
menu”).
8.8 Adjusting the coee grinder
The coee grinder does not require any adjustment, at least
initially, as it has been factory set to ensure that coee is pre-
pared correctly.
Loading ...
Loading ...
Loading ...