Loading ...
Loading ...
Loading ...
Note
●
The connection will be
terminated if you do not perform
any operation on the watch or
phone for a fixed amount of time
(connection limit time).
To specify the connection limit
time, perform the following
operation with G-SHOCK+:
“Watch settings”n“Basic
settings”n“Connection time”.
Next, specify a setting of 1 hour,
1.5 hours, or 2 hours.
Link Loss Alert
While there is a Bluetooth link between
the watch and a phone, the [LINKLOSS]
warning will appear on the watch display
in the following cases: if you do not
perform any phone operation, if the
distance between the watch and phone
becomes too great, if the phone is turned
off, if the connection is lost due to radio
interference or some other cause. A loss
of connection will cause the watch to
return to the Timekeeping Mode.
To re-connect, move the watch and
phone close to each other and then hold
down the watch’s (B) button for about 0.5
seconds.
●
If “Tone” is selected for the G-SHOCK
+ “Link loss alert” setting, the watch will
beep when link loss occurs.
l Configuring Watch Settings
Entering the Watch Airplane Mode
Use the Airplane Mode to disable
Bluetooth radio wave emissions.
Enter the Airplane Mode when in a
hospital, in an aircraft, or anywhere else
where radio wave emissions are
restricted.
Important!
●
The functions below are
disabled in the Airplane Mode.
ー
Auto adjust
ー
Song title search
ー
Phone finder
ー
Bluetooth connection
1.
X If the watch is connected with a
phone, hold down (B) for about 0.5
seconds to terminate the connection.
2.
X Hold down (C) for about four
seconds.
This causes the watch to enter the
Airplane Mode and displays the
Airplane indicator.
●
Each time the (C) button is held
down for about four seconds, the
watch enters or exits the Airplane
Mode.
Airplane indicator
Viewing Mobile Link Info
Use the procedure below to view Mobile
Link Info on the watch.
1.
X Hold down the (C) button for about
two seconds.
This will cause the watch to enter the
Timekeeping Mode.
●
If the watch is connected with a
phone, hold down (B) for about 0.5
seconds to terminate the
connection.
2.
X Press (C) five times to enter the
Setup Mode.
[SETUP] will appear on the display
followed by the watch device name.
Each press of (D) cycles the display
contents in the sequence shown
below.
Watch device name
p
Watch device address
p
Type of phone currently connected
*
* Displayed only when the watch is
paired with a phone.
3.
X Press (C) to return to the
Timekeeping Mode.
Clearing Pairing Info
To unpair the watch from a phone, delete
the pairing information from G-SHOCK+,
the phone, and the watch.
●
Clearing Pairing Information from
G-SHOCK+
1.
X If the watch is connected with a
phone, hold down (B) for about 0.5
seconds to terminate the connection.
2.
Y In the upper right corner of the G-
SHOCK+ top screen, tap i to
display the “Connection settings”
screen.
3.
Y On the “Previously registered
watch” list, select the one whose
pairing information you want to clear.
4.
Y Tap “Delete pairing registration”.
5.
Y Tap “Yes”.
This clears the watch’s pairing
information from G-SHOCK+.
Operation Guide 5413
6
Loading ...
Loading ...
Loading ...