Loading ...
Loading ...
Loading ...
Specifying the Light Duration
You can select either 1.5 seconds or
three seconds as the illumination
duration.
1. Press (C) to enter to the Timekeeping
Mode.
l Navigating Between Modes
2. Hold down the (A) button for about
two seconds.
[SET Hold] will appear, and then the
time zone setting will flash.
Time zone
3. Press (C) 10 times until the current
setting ([LT1] or [LT3]) flashes on the
display.
4. Rotate the rotary switch to display
the light duration you want to use.
[LT1]: 1.5-second light
[LT3]: 3-second light
Rotary
switch
5. Press (A) to exit the setting screen.
Hand Alignment Correction
Strong magnetism or impact can cause
the time indicated by the analog hands to
become different from the time on the
digital display. If this happens, correct the
hand position.
Getting ready
Perform this procedure in the
Timekeeping Mode. Use (C) to navigate
to the Timekeeping Mode.
l Navigating Between Modes
Timekeeping Mode
Adjusting Hand Alignment
1. Hold down the (A) button for about
five seconds.
[H.SET Hold] will appear, and then
[Sub] will flash.
Rotary
switch
Disk pointer
2. If the disk pointer is not at 12 o’clock,
rotate the rotary switch to move it
there.
●
Rotating the rotary switch quickly
three times starts high-speed
forward operation.
3. Press (C).
This enables correction of hour and
minute hand alignment.
●
Pressing (C) again will return to
disk pointer correction.
●
Button and rotary switch operation
are disabled while the hands are
moving.
Minute hand
Hour hand
4. If the hour and minute hands are not
at 12 o’clock, rotate the rotary switch
to move it there.
5. Press (A) to return to the
Timekeeping Mode.
Basic Settings
Getting ready
Perform this procedure in the
Timekeeping Mode. Use (C) to navigate
to the Timekeeping Mode.
l Navigating Between Modes
Timekeeping Mode
Enabling the Button
Operation Tone
Use the procedure below to enable or
disable the button operation tone.
1. Hold down the (A) button for about
two seconds.
[SET Hold] will appear, and then the
time zone setting will flash.
Time zone
2. Press the (C) button 9 times until the
current setting ([KEY♪] or [MUTE])
will flash on the display.
3. Rotate the rotary switch to display
[KEY♪] or [MUTE].
[KEY♪]: Enables the operation tone.
[MUTE]: Displays the mute indicator
and disables the operation tone.
Rotary
switch
Mute indicator
4. Press (A) to exit the setting screen.
Operation Guide 5413
12
Loading ...
Loading ...
Loading ...