Loading ...
Loading ...
Loading ...
6
THE PROCESSOR BOWL LID MUST BE LOCKED INTO POSITION ON THE PROCESSOR BOWL
1. Place the processor bowl lid over the processor bowl with the feed chute on the right,
aligningon the processor bowl lid with on the processor bowl.
2. Hold the food chute and rotate clockwise to alignon the processor bowl lid with on the
processor bowl until it clicks rmly into place.
3. This must be correctly in place before trying to operate the food processor.
IMPORTANT:
For your protection this appliance has an interlock system. The processor will not
operate unless the processor bowl and lid are properly aligned and locked into place.
Do not try to move the lid or the processor bowl while the motor is running.
The processor bowl cannot be removed from the motor unit when the lid is locked in
place. Remove the lid, then remove the processor bowl.
The processor bowl cannot be locked onto the motor unit when the lid is locked in place.
Remove the lid, then lock the processor bowl onto the motor unit.
OPERATING THE MULTI PROCESSOR
CAUTION: Always turn off and unplug from the wall power outlet before fitting or
removing attachments.
IMPORTANT: Do not run the motor for longer than 1 minute. After 1 minute, switch off for
at least 2 minutes to allow the motor to cool down.
HOW TO CHOP IN THE PROCESSOR BOWL
The chopping blades are used to process, chop, mince, mix and puree foods to a smooth
consistency.
CAUTION: DO NOT handle by the blade. The blade attachments are very sharp. Use
caution when handling and storing.
1. Ensure the black spindle is in position.
2. Lock the processor bowl onto the motor unit. (see page 5).
3. Lower the white centre post into the centre of the processor bowl, over the black spindle.
4. Hold the chopping blade by the plastic centre and insert it onto the white centre post and
slide it to the bottom of the bowl.
NOTE: The chopping blade will only fit correctly onto the white centre post one way.
5. Place food in the processor bowl.
NOTE: When processing only liquids, do not fill the processor bowl past max .
NOTE: When processing solids, or a combination of liquids and solids, do not fill past MAX.
6. Place the lid on the processor bowl and lock into place. (see page 6).
Loading ...
Loading ...
Loading ...