Loading ...
Loading ...
Loading ...
Problem solving guide
68
Message Possible cause and remedy
Clean the fluff filter.
Check the airways.
The plinth filter looks clean after thorough cleaning.
However, the programme is terminated again and the
fault message appears again. There are probably still
deeper residues which could not be removed.
To deactivate the message, confirm with OK.
Check all of the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
in "Problem solving guide - Checking the heat
exchanger".
The plinth filter is clogged on a deeper level.
Check the plinth filter. Follow the instructions in
"Problem solving guide - Replacing the plinth
filter".
If the plinth filter is not deformed or defective, you
can regenerate it in a washing machine. Follow the
instructions in "Problem solving guide -
Regenerating the plinth filter".
Empty the container
or check the drain
outlet
The condensed water container is full or there is a
kink in the drain hose.
Open and close the door with the tumble dryer
switched on to clear the message. Or switch the
tumble dryer off and then on again.
Empty the condensed water container.
Check the drain hose.
Obstruction
detected. Untangle
laundry and restart.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. If
necessary, take out some of the laundry.
Switch the dryer off and back on.
Start a programme.
Fault F. If restart
fails, call Service.
There is no obvious cause.
Switch the dryer off and back on.
Start a programme.
If the programme terminates again with the same
fault message, then there is a fault. Contact Miele.
Loading ...
Loading ...
Loading ...