Loading ...
Loading ...
Loading ...
47
WASHER CONTROLS AND SETTINGS
Reversed Hose Detection
If condition is detected where the inlet
hoses have been installed incorrectly (hot
supply to cold inlet and cold supply to hot
inlet), the washer will alert you. The LED will
display “HO” followed by “SE” and then the
remaining cycle time (0 min) for 60 seconds
and then repeat. Acknowledge the reversed
hose condition by pressing the cancel
button. Shut off each water supply valve and
attach each supply hose to the correct inlet
connection on the washer.
Drum Light (on select models)
The drum light will come on whenever
the door is opened to illuminate the drum
during loading and unloading. Closing the
door turns off the light. The drum light will
automatically turn off if the door is left open
more than 3 minutes.
Reversible Door
Your washer may be equipped with a
reversible door. The door can be hinged on
the right or left side.
Door Stand Ventilation
Help prevent odor buildup and reduce
humidity between washes by utilizing your
washer’s door stand ventilation feature.
Open the door, locate the stand below the
door latch and rotate the stand counter-
clockwise to unlock it.
The stand is spring loaded and will extend.
Rotate it clockwise to lock in the extended
position.
1
2
3
Trapped Item Detection
If an item is detected to be trapped between
the door and the door gasket, the washer
will pause the cycle and play an alert chime.
The LED will display a loop of “CLEAr door”
as shown below until the cancel button is
pressed. Press the cancel button to unlock
the door and remove the trapped item, then
close the door and restart the cycle.
To disengage the stand, rotate to unlock, push
the stand in and rotate to lock position.
NOTE
If unable to rotate the stand by hand, a coin
or flat blade screw driver can be used.
NOTE
If door stand will not turn to locked
position, fully turn it to unlock position and
try to lock again.
(60 sec loop)
(60 sec loop)
(60 sec loop)
Loading ...
Loading ...
Loading ...