Loading ...
Loading ...
Loading ...
M210/M210-LAB User Manual 73
Program
Invalid terminal repeat value
entered.
The value entered is out of the
range.
The acceptable range is between the
minimum of 0.2 inch (50.8mm) to the
maximum of 40 inches (1016mm).
Error - “Cannot Fit” Font size and settings too large
for label.
• Change the font size to a smaller font.
(See page 34.)
• Delete some text.
(See page 33.)
Error - “Cannot Fit” There are too many lines of text.
The maximum number of lines
allowed is four, but may be less
when using pre-sized labels.
A blank line is considered another line
of text. DO NOT press ENTER at the
end of a line if you DO NOT want
another line. (See page 32.)
Error - “Cannot Fit” Wrong label type or orientation
• Select a different label type (e.g.,
banner landscape). (See page 50.)
• Change orientation (vertical or
horizontal). (See page 51.)
“Cannot Fit” message received
while typing.
No more room on the label using
the font currently in use.
• Check the label type. Sometimes
wiremarker or fixed length is
accidentally selected rather than
banner.
• Check that an additional line of text
was not inadvertently added.
Left and right justification not
working.
The printer currently does not
support left or right justification.
All label text will be center
justified only.
No action required.
Text not centered on label. Possible blank spaces added to
text.
Press Clear , then re-
enter text.
A large section of blank label
prints after text.
Possible blank lines added after
text.
Press Clear , then re-
enter text.
Cannot change location of the
human readable text in a
barcode.
The human readable text is
automatically added below the
label. This position is fixed and
cannot be changed.
No action required.
Cannot add checksum character
in barcode.
The printer does not allow
checksum characters to be used.
No action required.
Problem Cause Corrective Action
Loading ...
Loading ...
Loading ...