Loading ...
Loading ...
Loading ...
Before YouCall ForService...
Troubleshooting -tips
Possible Causes What To Do
"F-- anda number
orletter"flash
in thedisplay
You have a function
error code.
• Press the CLEJlR/OFFpad. Put the oven back into
operation.
If the fmaction code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the flmction
error code repeats, call fl)r service.
• On sellXcleaning models, if a flulction error code
appears during the selt:cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, fl'om the locked position. Make sure the latch
is moved to the right as far as it will go. Press the
CLEAR/OFFpad.Mlow the oxen to cool for one houi:
Put the oven back into operation.
Display goes blank A fuse ha your home may be • Rel)lace the fi/se or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is turned off • See the Using the clock and timer section.
from showing in the display,
Displayflashes Power failure, • Reset the clock.
Unabletoget the Oven control pads were • The BAKE aud BROILHI/LO pads must be pressed
displayto show "SF" not pressed properly, at the same time and held for 3 seconds.
Power outage, Power outage or surge. • Reset the clock./f the oven was ill use, you uu/st reset
it by )ressing the CLEAR/OFFpad, ,, l , settiiw the clock
and resetting any cooking flulction.
"Burning" or "0i/y" This is normal ha a new • To speed the process, set a self:clean cycle fi)r a
odor emitting from oven and will disappear minimum of ?) hours. See the Using the self-
the vent in time, cleaning oven section.
Strongodor An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
32
Loading ...
Loading ...
Loading ...