Loading ...
Loading ...
Loading ...
13
23MMP3101REV1.0
28MMP7409REV1.0
15. Installing the tip restraint hardware
• When the Tipping Restraint Hardware (HH) is
properly installed, it can provide protection
against unexpected tipping of the Unit due to
small tremors, bumps or climbing.
• Each Tipping Restraint Hardware (HH) includes
one Unit Anchor, one Wall Anchor, one Anchor
Tether, and four Anchor Screws. Use these to
complete the following steps for a proper
installation.
• Locate a secure wall stud behind the unit closest
to left side.
• Align the Unit Anchor with a wall stud and attach
with two Anchor Screws using a Philips Screw-
driver. The Anchor Screws must pass through
the Top Assembly for proper installation.
• Align the Wall Anchor in the center of the wall stud, at level with the Unit Anchor, and attach with
two Anchor Screws using a Philips Screwdriver.
• On the Anchor Tether, detach the cable from the connector and loop the loose cable through
the eyelets on the Wall Anchor and Unit Anchor. Reattach the loose cable to the connector,
but do not tighten.
• Locate a secure wall stud behind the unit closest to the right side and repeat the steps above.
• Tighten both Anchor Tethers by pulling the cable the through connector.
NOTE: Installation of the Tipping Restraint Hardware (HH) will provide a small space between the wall
and the unit. This will allow you to run power cords and connector cables to your television or other
devices placed on top of the unit.
WARNING: Installing the Tipping Restraint Hardware will help prevent accidents or damage to the unit.
HH
Hardware Used
x 1
15
ASSEMBLY INSTRUCTIONS
Tipping Restraint Hardware
Loading ...
Loading ...
Loading ...