Loading ...
Loading ...
Loading ...
5-10
5-10
Frame servicing
2
1
5
4
3
2
1
(1) CILINDER ASSY
(2) CENTER BOLT
Hold the axle holder in a vise protected with a piece of
wood or soft jaws to avoid damage.
Do not overtighten the vise.
Clean and apply a locking agent to the center bolt threads.
Install the center bolt with a new sealing washer.
Hold the cylinder assembly using the special or generic
tool, then tighten the center bolt to the specified torque.
Tool:
Fork damper holder 07930–KA50100
Torque: 34 N•m (3.5 kgf•m)
(1) GUIDE BUSHING
(2) BACK-UP RING
(3) OIL SEAL
(4) STOP RING
(5) DUST SEAL
Install the following parts onto the fork tube using the
same procedure as the right fork (page 5-6):
– Fork tube bushing
– Guide bushing
– Back-up ring
Using the special tool, drive the guide bushing and backup
ring until the stop ring groove is fully stuck in the fork
slider base.
Install the oil seal (with the mark facing up) in the fork
slider. Drive the oil seal using the special tool, performing
a constant pressure until stops in back-up ring.
Tool:
Fork seal driver 07947–4630100
Install the stop ring into the slider groove securely.
Install the dust seal.
Pour half the required amount of recommended fork fluid
in the fork leg.
Specified fork fluid:
Showa SS05 (SAE 5W) o equivalente
Pump the fork tube slowly 8-10 times.
Pour additional fluid to the specified capacity.
Oil level: 87 mm (3.4 in)
Oil capacity (orientative): 410 cc (13.9 US oz, 14.4 Imp oz)
Loading ...
Loading ...
Loading ...