Loading ...
Loading ...
Loading ...
5-7
5-7
Frame servicing
(1) FORK DAMPER ROD
(2) OIL LEVEL
2. Pump the damper rod 8 - 10 times.
3. Make sure no air in fork damper by slowly pull the
damper rod up. If the resistance is felt at the top end,
pump the damper rod again.
Wait 2 – 3 minutes before measuring the oil level.
Measure the oil level from top of the fork tube, with the
fork fully compresed.
Standard oil level: 51 mm (2.0 in)
Oil capacity (orientative): 405 cm3 (13.7 US oz, 14.3 Imp oz)
Pour recommended fork fluid in the fork leg.
Specified fork fluid:
Showa SS05 (SAE 5W) or equivalent
Bleed the air as follows:
1. Extend the fork. Cover the top of the fork tube with
your hand and compress the fork slowly several times.
(1) FORK FLUID
(2) FORK TUBE
Hold the axle holder in a vise protected with a piece of
woods or soft jaws to avoid damage.
Do not overtighten the vise.
Install the right fork center bolt with a new sealing was-
her.
Hold the fork damper using a generic tool, then tighten
the right fork center bolt to the specified torque.
Tool:
Fork damper holder (Generic tool)
Torque: 34 N•m (3.5 kgf•m, 25 lbf•ft)
(1) FORK DAMPER
(2) RIGHT FORK CENTER BOLT
2
1
2
1
1
2
Loading ...
Loading ...
Loading ...