Loading ...
Loading ...
Loading ...
4.7 To charge the battery
WARNING: Only charge the product
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
When the product is new or has been stored for a long
period, the battery can be empty and needs to be
charged before starting. In the
Main area
mode, the
product automatically alternates between mowing and
charging.
1. Push the ON/OFF for 3 seconds button to start the
product.
2. Place the product in the charging station. Slide the
product in as far as possible to ensure proper
contact between the product and the charging
station. Refer to contact and charging plates in
Product overview on page 4
3. The display shows a message that charging is in
progress.
4.8 Adjust the cutting height
The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (5 cm / 2 in.).
CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
4.8.1 To adjust the cutting height
1. Push the STOP button to stop the product.
2. Open the hatch.
6
5
3. Turn the knob to the required position.
• Turn clockwise to increase the cutting height.
• Turn counter-clockwise to decrease the
cutting height.
4. Close the hatch.
28 - Operation 1411 - 007 - 23.09.2020
Loading ...
Loading ...
Loading ...