Loading ...
Loading ...
Loading ...
3. Place seat on seat pan so head of
shoulder bolt is positioned over large
slotted hole in pan.
4. Push down on seat to engage
shoulder bolt in slot and pull seat
towards rear of tractor.
5. Pivot seat and pan forward end
assemble adjustment knob and flat
washer loosely. Oo not tighten.
6. Lower seat into operating position and
sit in seat.
7. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
8. Get offseat withoutmoving its
adjusted position.
9. Raise seat and tighten adjustment
knob securely.
Seat
SeatP_
Shoulder
Bolt
NOTE: You may now rollor drive your
tractor off the skid. Followthe appropriate
instruction below to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Press lift lever plunger and raise
attachmentliftlever to its highest
position.
2. Release parking brake by depressing
clutch/brake pedal.
3. Place gearshift lever in neutral (N)
position.
4. Roll tractorforward offskid.
TO DRIVE TRACTOR OFF SKID (See
Operation section for location and
function of controls)
_WARNING: Before starting,read
understand and follow all instructions in
the Operation section of this manual Be
sure tractor is in a well-ventilated area. Be
sure the area infront oftractorisclearof
other people and objects.
1. Be sure all the above assembly steps
have been completed.
2. Check engine oil level and fill fuel
tank with gasoline.
3. Sit on seat in operating position,
depress dutch/brake pedal and set
the parking brake.
4. Place gear shift lever in neutral (N'I
position.
5. Press lift lever plunger and raise
attachment lift lever to its highest
position.
6. Start the engine. After engine has
started, move throttle control to idle
position.
7. Depress clutch/brake pedal into full
"BRAKE" position and hold. Move
gearshift lever to 1st gear.
8. Slowly release clutch/brake pedal and
slowly drive tractor off skid.
9. Apply brake to stop tractor, set parking
braise and place gearshift lever in
neutral position.
10.Turn ignition key to "OFF" position.
Continue with the instructions that follow.
ASSEMBLE GAUGE WHEELS TO
MOWER DECK
The gauge wheels are designed to keep
the mower deck in proper positionwhen
operating mower. Be sure they are
properly adjusted to ensure optimum
mower performance.
1. Slide gauge wheel bar down into
bracket channel, Be sure that gauge
wheel bar aligningholes are on top.
Assemble gauge wheels as shown
using shoulderbolts, 3/8 washers end
3/8-16 center Iocknuts and tighten
securely.
2. For ease of mower to tractorassem-
bly, raise gauge wheels to highest
positionand retain with clevis pins
and spring retainers.
NOTE: Adjust gauge wheels before
operatingmower. See "TO ADJUST
GAUGE WHEELS" in the Operation
sectionof this manual.
Loading ...
Loading ...
Loading ...