Loading ...
Loading ...
Loading ...
14.Carefullyrollbeltintouppergrooveof
R.H.mandrelpulley.
15.Carefu_tycheck bert routingmaking
sure belt is in the grooves correctly.
16.Reconnect R.H. suspension arm to
rear deck bracket with retainer spring.
17.Reassemble R.H. mandrel cover.
18.Engage belt tension rod by pushing
rod into locking bracket.
Belt_ensionRod R.H. =1
(Disengaged Mandrel
Position) Electric
_._ Idler /Clutch
' PUll Pul_ey
12. Reinstall mower to tractor (See
"INSTALL MOWER AND DRIVE BELT"
in the Assembly sectionof this manual).
13,Reassemble mowerdrive belt (See
"TO REPLACE MOWER DRIVE BELT"
inthis sectionofthismanual).
L,H. Mandrel Secondary Idler Arm
Y
Sp_ng Arm
Spdng
R.H. Suspension Am
Priraary [alter
TO REPLACE MOWER BLADE DRIVE
BELT
Parkthe tractoron level surface. Engage
parking brake.
1. Remove mowerdrive belt (See "TO
REPLACE MOWER DRIVE BELT"in
this sectionofthis manual).
2. Remove mower (See "TO REMOVE
MOWER" inthis sectionofthis manual).
3. Remove screwsfrom L.H. mandrel
cover and remove cover.
4, Carefullyroll belt off L.H. mandrel
pulley.
5. Remove bertfrom center mandrel
pulley, idler pulley, and R.H. mandrel
pulley.
6. Remove any dirt or grass which may
have accumulated around mandrels
and entire upper deck surface.
7. Check secondaryidler arm and idler
pulley to see that they rotate freely.
8. Be surespdng is hooked in secondary
idler arm and secondary spring arm.
9. Install new belt in lower grooveof R.H.
mandrel pulley, idler pulley, and center
mandrel pulley as shown.
10.Carefufly roll belt over L.H. mandrel
pulley. Make sure belt is in all grooves
properly.
11.Reinstall L.H. mandrel cover.
Center Mandrel
R.H. Mendel
TO ADJUST BRAKE
Your tractoris equipped withan adiustabte
brake system whichismounted on the
side ofthe transaxle.
Iftractorrequiresmorethan six(6) feet
stopping distance at high speed in highest
gear on a level dry concrete or paved
surface, then brake must be adjusted.
1. Depress clutch/brakepedal and
engage parking brake.
2. Measure distance between brake
operating arm and nut "A" on brake rod.
3. If distance is other than 1-1/2", loosen
jam nut and turn nut "A" until distance
becomes 1-1/2". Retighten jam nut
against nut "A".
4, Road test tractorforproper stopping
distance as statedabove. Readjustif
necessary. If stoppingdistance is still
greaterthan six (6) feet in highestgear,
further maintenanceis necessary,
Contact a Sears or other qualified
service center,
WITH PARKING BRAKE "ENGAGED"
Nut =A"
J_ Nut
Operating
Arm
24
Loading ...
Loading ...
Loading ...