Loading ...
Loading ...
Loading ...
Yournewtractorhasbeenassembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your
tractor all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness. Review the video cassette before
you begin.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16" Wrench (1) 3/4" Socket w/
(1) 1/2" wrench drive ratchet
(1) Utility knife (1) Pliers
(1) Tire pressure gauge
When dght or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating
position (seated behind the steering
wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1. Remove all accessible loose parts
and parts boxes from shipping carton.
2. Cut, from top to bottom, along lines on
all four corners of shipping carton, and
lay panels flat.
3. Remove mower and package materi-
als.
4. Check for any additional loose parts
or boxes and remove.
BEFORE REMOVING TRACTOR
FROM SKID
ATTACH STEERING WHEEL
t. Remove lock nutand large flat washer
from steeringshaft.
2. Positionfront whee[s o1the tractor so
they are pointingstraightforward.
3. Slide the steering sleeve over the
steering shaft.
4. Positionsteering wheel so crossbars
are horizontal(left to right)and slide
onto steering wheel adapter.
5. Secure steering wheel to steering
shaft with lock nutand large flat
washer previouslyremoved. Tighten
securely.
6, Snap steering wheel insertinto center
of steering wheel.
7. Remove protective materials from
tractor hood and grill.
IMPORTANT: Check for and remove any
staplesin skid that may puncture tires
where tractor isto roltoff skid,
SteeringWheel
_ _lnsert
SteeringWheel _
Whee, 4
SteeringWheel
Adaptor_ -'" .
Steering
Shaft
Sleeve
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY
t. Lifthood to raisedposition,
NOTE: Ifthis battery is put intoservice
after monthand year indicatedon label
(label located between terminals) charge
battery for minimum ofone hour at 6-10
amps. (See "BATTERY"in MAINTE-
NANCE sectionof this manual for
charging instructions).
.- . ..' Label
INSTALL SEAT
Adjustseat before tighteningadjustment
knob,
1. Remove adjustment knob and flat
washer securingseat to cardboard
packing and set aside for assembly o1
seat to tractor.
2, Pivot seat upward and remove from
the cardboard packing. Remove the
cardboard packing and discard.
8
Loading ...
Loading ...
Loading ...