39616 ver1 04/10
FCC statement
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
FCC NOTE: The manufacturer is not
responsible for any radio or TV
interference caused by unauthorized
modifications to this equipment. Such
modifications could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures: reorient or relocate
the receiving antenna, increase the
separation between the equipment and
receiver, or connect the equipment into
an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
CAUTION
BATTERIES MAY LEAK HARMFUL LIQUIDS
OR IGNITABLE MATERIALS OR EXPLODE
CAUSING INJURY OR PRODUCT DAMAGE.
• DO NOT MIX OLD AND NEW OR OTHER
BATTERY TYPES
• REPLACE ALL BATTERIES AT THE SAME
TIME
• REPLACE FULLY DISCHARGED
BATTERIES IMMEDIATELY
• REMOVE BATTERIES IF PRODUCT IS TO
BE UNUSED FOR EXTENDED PERIOD
OF TIME
The lantern is operated with 6 D cell batteries (not included). Batteries must be installed or replaced in sets of six.
NOTE: If replacing the batteries, remove the old batteries and follow the instructions below.
battery installation:
illustration 1
illustration 2
illustration 3
using the latching handle:
1. To open the handle, depress the raised
button near the bottom of the handle.
See illustration 1.
2. Fully open the handle.
3.Close handle around object you wish the
lantern to hang from. See illustration 2.
4.LOpen the raised button. Be sure the
handle is securely latched before allowing
lantern to fully hang on its own. See
illustration 3.
• Do not attempt to hang lantern with
handle in open position.
• Always be sure to hang the lantern in a
safe and secure area.
• Lantern should never be left out in
excessive wind.
usb charging:
Rating: 1A@5V
USB charging port may not charge all
devices. Some devices require a proprietary
USB power supply.
1. Turn the lantern over and
remove the battery cover by
twisting the cap counter
clockwise.
2. To run the lantern from 6 D
cells, fill all six positions noting
proper battery polarity.
3. Replace the battery cover by
fitting the center plastic column
within the base and then
twisting the cover clockwise
until it clicks firmly into place.
Made in China
GE is a trademark of General Electric
Company and is under license by Jasco
Products Company LLC, 10 E. Memorial Rd.,
Oklahoma City, OK 73114.
This Jasco product comes with
a 5-year limited warranty.
Visit www.byjasco.com for details.
Questions? Contact us at 1-800-654-8483
between 7:00AM—8:00PM CST.
LED Lantern User’s Guide
