Loading ...
Loading ...
3
INSTALLATION INSTRUCTIONS
Tools and Parts
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
Tools needed:
Parts supplied:
Remove parts package from the washer basket. Check that all
parts are included.
Parts needed:
Check local codes and with gas supplier, check existing gas
supply, electrical supply and venting, and read “Electrical
Requirements,” “Gas Supply Requirements” and “Venting
Requirements” before purchasing parts.
Mobile home installations require special parts (listed following)
available for purchase from the dealer from whom you purchased
your dryer. For further information, please reference the
“Assistance or Service” section of your “Washer/Dryer User
Instructions.”
■
Mobile Home Installation Kit. Ask for Part Number 346764.
■
Metal exhaust system hardware.
Alternate Parts
Your installation may require additional parts. For ordering
information, please refer to the toll free phone numbers on the
front page of your “Washer/Dryer User Instructions.”
Location Requirements
You will need
■
A location that allows for proper exhaust installation. A gas
washer/dryer must be exhausted to the outdoors. See
“Venting Requirements.”
■
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the washer/dryer. See “Electrical Requirements.”
■
8 in. or 10 in. adjustable
wrench (for gas
connections)
■
Flat-blade screwdriver
■
Adjustable wrench that
opens to 1 in. (2.5 cm) or
⁹⁄₁₆
in. (14 mm) open-end
wrench (for adjusting
dryer feet)
■
Level
■
¼ in. nut driver or socket
wrench
■
Wood block (for leveling)
■
Ruler or measuring tape
■
Knife
■
Safety glasses
■
Vent clamps
■
Pipe-joint compound
resistant to L.P. gas
■
Caulking gun and
compound (for installing
new exhaust vent)
■
Gloves
■
Pliers that open to
1
⁹⁄₁₆
in. (3.95 cm)
■
Scissors
■
Tin snips (new vent
installation)
1. Water inlet hoses (2)
2. Inlet hose flat washers (4)
3. Front leveling feet with nuts (2)
4. Shipping strap (not in parts bag,
see “Remove Shipping Strap”)
5. Drain hose
6. Yellow, single wire
hose clamp
7. Silver, double wire
hose clamp
If You Have You Will Need to Buy
Laundry tub or
standpipe taller than
96 in. (2.4 m)
Sump pump system (if not already
available)
1 in. (2.5 cm)
diameter standpipe
2 in. (5 cm) diameter to 1 in. (2.5 cm)
diameter standpipe adapter, Part
Number 3363920
Overhead sewer Standard 20 gal. (76 L) 34 in. (86.4 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain Drain protector, Part Number 367031
Water faucets
beyond reach of fill
hoses
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Failure to do so can result in death, explosion, or fire.
Loading ...
Loading ...
Loading ...