Loading ...
Loading ...
Loading ...
Complete Installation
1.
Check to be sure all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2.
Check to be sure you have all of your tools.
3.
Dispose/recycle all packaging materials. Keep the plastic
foam for use if the washer/dryer should be transported.
4.
Check the washer/dryer’s final location. Be sure the vent is not
crushed or kinked.
5.
Check to be sure the washer/dryer is level and front leveling
feet are tight. See “Level Washer/Dryer.”
6.
Plug into a grounded 3 prong outlet. Turn power on.
7.
Check to be sure the water faucets are on.
8.
Check for leaks around faucets and inlet hoses.
9.
Remove the blue protective film on the console and any tape
remaining on the washer/dryer.
10.
Read your “Washer/Dryer User Instructions.”
11.
Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
12.
To test the washer, measure
¹⁄₂
the normal recommended
amount of detergent and pour it into the washer. Close the lid.
Select HEAVY DUTY and pull out the Cycle Control knob.
Allow the washer to complete one whole cycle.
13.
To test the dryer, set the dryer on a full heat cycle (not an air
cycle) for 20 minutes and start the dryer.
If the dryer will not start, check the following:
■
Washer/dryer is plugged into a grounded 3 prong outlet.
■
Start button has been firmly pushed.
■
Electrical supply is connected.
■
House fuse is intact and tight; or circuit breaker has not
tripped.
■
Dryer door is closed.
14.
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you do not feel heat, turn the
dryer off and check to see whether the gas supply line shutoff
valve is open.
■
If the gas supply line shutoff valve is closed, open it, then
repeat the 5-minute test as outlined above.
■
If the gas supply line shutoff valve is open, contact a
qualified technician.
8542750
© 2003.
All rights reserved.
Benton Harbor, Michigan 49022
TM DURASAFE is a trademark of Whirlpool, U.S.A.
7/03
Printed in U.S.A.