Loading ...
Loading ...
Loading ...
11
2.
If the washer/dryer is not level, prop up the front with the
wood block and adjust the feet up or down as necessary.
Remove wood block.
3.
Tilt the washer/dryer forward until the rear of the washer/dryer
is at least 4 in. (10.2 cm) off the floor. You may hear the self-
adjusting rear feet click into place. Lower the washer/dryer to
the floor. Check the levelness of the washer/dryer with a level
as shown above.
If washer/dryer will not level, recheck rear leveling legs for free
movement as described in the “Install Leveling Legs” section.
Repeat until the washer/dryer is level.
NOTE:
It may be necessary to level the dryer again after it is
moved into its final position.
4.
After the washer/dryer is in the final location and level, use an
adjustable or open-end wrench to turn the nuts on the front
feet tightly against the washer cabinet.
If the nuts are not tight against the washer cabinet, the
washer/dryer may vibrate.
Make Gas Connection
1.
Remove the red cap from the flexible gas connector.
2.
Remove the ½ in. NPT adapter from the flexible gas connector
(it will be necessary to use two adjustable wrenches).
3.
Install the adapter on the ½ in. rigid gas supply pipe using
pipe-joint compound.
NOTE:
For L.P. gas connections, you must use pipe-joint
compound resistant to the action of L.P. gas. Do not use
TEFLON
®
tape.
4.
Attach the flexible gas connector to the ½ in. NPT adapter. Do
not use pipe-joint compound for this connection.
There should be a natural loop in the flexible gas connector.
The flexible gas connector must not be twisted, kinked or
attached with any sharp bends.
5.
All connections must be wrench tightened.
6.
Open the shutoff valve in the supply. The valve is open when
the handle is parallel to the gas pipe.
7.
Test all connections by brushing on an approved noncorrosive
leak-detection solution. Bubbles will show a leak. Correct any
leak found.
Connect Vent
1.
Using a 4 in. (10.2 cm) clamp, connect vent to exhaust outlet
in washer/dryer. If connecting to existing vent, make sure the
vent is clean. The vent must fit over the exhaust outlet and
inside the exhaust hood. Make sure the vent is secured to
exhaust hood with a 4 in. (10.2 cm) clamp.
2.
Move washer/dryer into final position. Do not crush or kink
vent. Make sure washer/dryer is level.
3.
(On gas models) Check to be sure there are no kinks in the
flexible gas line.
1. ½ in. rigid gas supply pipe
2. Use pipe-joint compound
3. ½ in. NPT adapter
4. Do not use pipe-joint compound
5. Flexible gas connector
2
1
3
4
5
1. Closed valve
2. Open valve
Loading ...