Loading ...
Loading ...
Loading ...
EN
38
Cleaning and maintenance
www.bora.com
i
If the cover flap is not properly installed in its locking
mechanism, it will not close fully.
i
If the grease filter or cover flap are not fitted properly, the
control knob display shows an error message
E
0
1
2
or
E
0
1
3
(see the Troubleshooting chapter).
Removing the maintenance tray
i
The maintenance tray cannot be removed in the following
installation situations: single installation, 2nd adjacent
extractor, adjacent wok cooktop.
i
To remove the maintenance tray, the grease filter and
filter tray must be removed first.
2 1
Fig. 8.4 Removing the maintenance tray
[1] Maintenance tray
[2] Lock
XX
Turn the two levers of the lock [2] outwards 90° to unlock the
maintenance tray [1].
XX
Lift the maintenance tray [1] out of the cooktop extractor.
Installing the maintenance tray
Fig. 8.5 Installing the maintenance tray
Fitting the cover flap, grease filter and filter tray
Fig. 8.2 Fitting the components
XX
If necessary, activate the cooktop extractor cleaning function.
XX
Insert the filter tray in the opening on the extractor.
XX
Insert the grease filter into the opening in the extractor.
XX
Ensure that the grease filter sits correctly in the gap in the
housing.
Fitting the cover flap:
1 2 3
Fig. 8.3 Fitting the cover ap
[1] Extractor opening
[2] Holder
[3] Cover flap
XX
Lay the cover flap [3] on its side next to the extractor opening
[1].
XX
Allow the cover flap [3] to slide diagonally into the holder [2].
XX
Press the ends of the cover flap [3] lightly from above until you
hear them click into place.
XX
Make sure that the cover flap [3] has been fitted correctly.
Loading ...
Loading ...
Loading ...