Loading ...
Loading ...
Loading ...
BE positivu switch is "OFF" and power cord unplugged
thfu out entre p_ocedure.
REMOVE CARRIAGE STOP SCREW, LOCKWASHER
AND TAG. Read and understand warning tag before
discarding.
..............
_ _"-- 'L' Wq.ENC_
HEX
SUPPLIED
LOCK ARM BEFORE PROCEEDING.
HOLDING CARRIAGE ASSEMBLY WITH BOTH
HANDS, CAREFULLY START AND SLIDE THE
CARRIAGE ONTO THE TRACKS. The assembly must be
held parallel with_the arm so that all four bearings slide
smoothly onto the arm, preventing any excessive strain on
bearings and track.
WARNING: REINSTALL CARRIAGE STOP SCREW TO
PREVENT CARRIAGE FROM ROLLING OFF ARM.
Check for looseness of carriage bearings. Refer to
"Adjusting Carriage Bearings" in "Adjustments to
Compensate for Wear" Section.
INSTALL ARM CAP AND ARM CAP TRIM
WARNING: Make certain power cord is unplugged.
1. Insert finger under end of switch lever and pull end out
to the "ON" position.
2. Place arm cap in position and install screws.
3. Attach arm cap trim using screws.
4. Push switch to "OFF" position.
REMOVE SHIPPING SCREWS FROM BOTTOM SIDE
OF MOTOR AND DISCARD.
Use of pliers may be necessary.
ARM CAP
-_._ _ \ SCREW
VIEW OF UNDERSIDE OF MOTOR SCREW
SHOWING LOCATION OF TWO
SHIPPING SCREWS
V
REMOVE SAW BLADE.
1. Tighten carriage lock knob.
2. Loosen guard clamp screw, remove guard.
3. Motor shaft has left hand threads. Hold shaft wrench
and rotate arbor wrench down (clockwise).
4. Remove shaft nut, outer collar, saw blade, and inner
collar. Set aside and out of the way.
BLADE
ROTATION
PULL DOWN
TO LOOSEN
11
Loading ...
Loading ...
Loading ...