Loading ...
Loading ...
Loading ...
assembly and alignment
REMOVE SKIDS FROM BASE
MOUNTING SAW
1. From amonq the loose parts, find the following
hardware:
4 Hex Head Screws, 5/16-18 x 5/8
4 Lockwasher, 5/16 in. External Type
8 Washers, 1!/32 ID
4 Hex Jam Nuts, 5/16-18
2. Place saw orl legs so that holes in bottom of saw line up
with holes marked X in top of legs.
3. Install screws, washers and nuts as shown.
If you mount th,_ saw on any other Craftsman base or flat
bench, make sure Elevation Crank has proper clearance to
rotate. The saw must be boli:ed down. Position saw to slope
slightly rearward, so when the carriage is installed it will not
roll forward due to gravity,
HE,: FdLT
LEG
R.H. S[IF ENER
l
o_o 0 0
x
L.F]. ' TI_-F [ hJ B! f(
,k 0 ooo
x
x
o oI
000
i
x
,IL
"v
O ooo
ATTACH ELEVATION CRANK.
Install setscrew h_to crank. Install crank on elevation shaft.
Be sure setscrew is tightened on flat of shaft.
ELEVATE ARM TO ITS MAXIMUM HEIGHT.
Remove shipping block and discard.
ELEVATIOIN CRANK
TL!RN CLOCKWISE)
lo
Loading ...
Loading ...
Loading ...