Loading ...
Loading ...
Loading ...
19
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILLTANKInsucientwaterinthetank.Fill the tank with water and/or insert it
correctly, pushing it as far as it will go until it
clicks into place (g. 3).
EMPTY GROUNDS CONTAINER The grounds container (A14) is full. Empty the grounds container and drip tray,
clean and replace (g. 23).
Important: when removing the drip tray, the
grounds container MUST be emptied, even if it
contains few grounds.
If this is not done, when you make the next
coees, the grounds container may ll up
more than expected and clog the machine.
GROUND TOO FINE ADJUST
MILL
The grinding is too ne and the coee is
delivered too slowly or not at all.
The grinding is too ne and the coee is
delivered too slowly or not at all.
Repeat coee delivery and turn the grinding
adjustment dial (g. 10) one click clockwise
towards “7” while the coee mill is in
operation. If after making at least 2 coees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct
(see the section: Adjusting the coee mill”
on page 12). If the problem persists, make
sure the water tank is fully inserted, press the
button and deliver a little water from
the spout.
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
been replaced.
Remove the drip tray and insert the grounds
container.
ADD PRE-GROUND COFFEE With the pre-ground function selected,
pre-ground coee has not been poured into
the funnel.
Place pre-ground coee in the funnel or
deselect the “pre-ground” function (g. 14).
DESCALE The machine must be descaled. The descaling procedure described in the
section “Descaling needs to be performed as
soon as possible (page 16).
LESS COFFEE Too much coee has been used. Select a milder taste by pressing the dial
(g. 7) or reduce the quantity of pre-
ground coee.
FILL BEANS CONTAINER The coee beans have run out. Fill the beans container (g. 11).
The pre-ground coee funnel is clogged. Empty the funnel with the help of a brush as
described in the section “Cleaning the pre-
ground coee funnel”.
INSERT INFUSER ASSEMBLY The infuser has not been replaced after
cleaning.
Insert the infuser as described in the
paragraph “Cleaning the infuser”.
Loading ...
Loading ...