Loading ...
Loading ...
Loading ...
16. Connecting to Other Devices
444
0 If [USB Mode] is set to [PictBridge(PTP)] in the [Setup] ([IN/OUT]) menu, the
camera will be automatically connected to the printer without the [USB Mode]
selection screen being displayed. (l
355)
0 Do not use any other USB connection cables except the supplied USB
connection cables (C–C and A–C).
0 Take care not to turn off the camera while printing is in progress.
0 When connecting with the printer is not possible, set [USB Power Supply] to
[OFF] and then try connecting again. (l
355)
0 Do not disconnect the USB connection cable while [å] (Cable disconnect
prohibit icon) is displayed.
0 Disconnect the USB connection cable after printing.
0 Turn off the camera and disconnect the USB connection cable before
removing the card from the camera. Otherwise, the recorded data may be
damaged.
0 To print images with paper size and layout settings not supported by the
camera, set the [Paper Size] and [Page Layout] to [{] and then select the
desired settings on the printer.
(For details, refer to the operating instructions for your printer.)
0 If a yellow [¥] is displayed during printing, the camera is receiving an error
message from the printer.
After printing finishes, check that there is no problem with the printer.
0 If the number of prints is high, the pictures may be printed in batches. In this
case, the remaining number of prints indicated may differ from the number set.
0 When you print RAW images, JPEG images that were recorded at the same
time will be printed. If JPEG images were not recorded, printing is not
possible.
0 Recorded images cannot be printed while you are using the following
functions:
– Video recording/[6K/4K Burst]/[Post-Focus]
– [HLG Photo]
Loading ...
Loading ...
Loading ...