Loading ...
Loading ...
Loading ...
RECOMMENDED ACCESSORIES
ITEM CAT. NO,
Saw Blades ......................... See Catalog
*Molding Head Set ...................... 9-3222
Dado Insert ............................ 9-22281
Molding Insert ........................... 9-22282
Taper Jig ................................. 9-3233
Dado Set ............................... 9-32581
ITEM CAT. NO.
Steel Legs ............................... 9-22236
Retractable Caster Set .................... 9-22221
9-22222
"Power Tool Know How Handbook"
Table Saw ............................. 9-2918
*Smaller Diameter Molding Heads cannot be used
because they do not provide adequate depth of
cut
The above recommended accessories are current
and were available at the time this manual was
printed
TROUBLE SHOOTING
WARNING: TO AVOID INJURY FROM
ACCIDENTAL START, TURN SWITCH "OFF" AND
ALWAYS REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE TROUBLE SHOOTING.
TROUBLE SHOOTING -- GENERAL
TROUBLE PROBABLE CAUSE REMEDY
Excessive vibration, t Blade out of balance 1 Discard Blade and use a different blade
1 1 See section 'Miter Gauge"
Sharpen or replace blade
Cannot make square cut
when crosscutting_
Cuts binds, burns or 1
stalls motor when
ripping_ 2
Miter gauge not adjusted
properly
Dull blade with improper
tooth set
Warped board
3 Rip fence not parallel
to blade
4 Spreader out of
alignment
1 Stop nuts not properly
adjusted
1 Sawdust on threads of tilt
screw or elevating screw
1. Blade has excessive
wobble
2 Blade collars not installed
properly
1
2
3
4
Make sure concave or hollow side is facing
'down" feed slowly
See "Assembly" section, *Aligning Rip Fence"
See "Assembly" section. "Installing
Blade Guard "
Cut not true at 90 ° t See 'Assembly" section, _Blade Tilt, or
or 45 ° positions, "Squareness of Blade to Table"
Tilt crank and elevating t See "Maintenance and Lubrication" section
crank turn hard.
Excessive blade wobble° 1 Replace blade
(Causes oversize kerr
and unsmooth cut) 2 Make sure the _arge collar (2" Dia )
is between motor and blade (Installed
before blade)
33
Loading ...
Loading ...
Loading ...