Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR SAW
5 BLADE GUARD
SPREADER 6 TABLE INSERT
\
8 SAW BLADE "k* RIP FENCE
TABLE EXTENSION
4 MITER
GUAGE
MITER GUAGE
LOCK KNOB
3TILT HANDWHEEL
POWER CORD
T
TABLE
EXTENSION
RIP FENCE
LOCK KNOB
,BEVEL SCALE
BEVEL POINTER
2 ELEVATION HANDWHEEL
1 ON-OFF SWITCH
1. ON-OFF SWITCH
CAUTION: Before turning switch on, make sure
the blade guard is correctly installed and
operating properly,
The On-Off Switch has a locking feature. THiS
FEATURE IS INTENDED TO HELP PREVENT
UNAUTHORIZED AND POSSIBLE HAZARDOUS
USE BY CHILDREN AND OTHERS
A Insert Key into switch
B TO turn saw ON stand to either side of the
blade never in line with it. insert finger under
switch lever and pull END of lever out
After turning switch ON, always allow the
blade to come up to fuff speed before cutting
Do not cycle the motor switch on and off
rapidly, as this may cause the sawblade to
loosen In the event this should ever occur,
allow the sawblade to come to a complete stop
and retighten the arbor nut normally, not
excessively. Never leave the saw while the
power is "ON"
C TO turn saw OFF PUSH lever in Never
leave the saw until the cutting toot has come to
a complete stop
D To lock switch in OFF position hold switch
IN with one hand REMOVE key with other
hand
WARNING: FOR YOUR OWN SAFETY,
LOWER BLADE OR OTHER CUTTING TOOL
BELOW TABLE SURFACE. (IF BLADE IS
TILTED, RETURN IT TO VERTICAL (90 °)
POSITION). ALWAYS LOCK THE SWITCH
f
INSERT KEY
TURN O\F_F _, _ \_-=_,_
TURN ON
REMOVE KEY
"OFF", WHEN SAW IS NOT IN USE o , .
REMOVE KEY AND KEEP IT IN A SAFE
PLACE . , . ALSO , , . IN THE EVENT OF A
POWER FAILURE (ALL OF YOUR LIGHTS
GO OUT) TURN SWITCH OFF,. , LOCK IT
AND REMOVE THE KEY. THIS WILL
PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK
ON.
2O
Loading ...
Loading ...
Loading ...