Loading ...
Loading ...
Loading ...
15
e. Adjust the front and rear levelling feet (Fig. 27) if
necessary to align the edges of the trims to the
front face of the cabinetry.
To raise
back of the
unit, adjust
bolt clockwise
To raise front
of the unit,
adjust the
front feet
f. Adjust the leg levellers (Fig. 28) so that they touch the
ground and can’t be rotated further by bare hands.
This will stop the refrigerator rolling forward when
opening the doors.
g. Remove the screws holding the side trim to the top
trim and take out the side trim by carefully sliding it
up and away from the unit.
h. Drill dia 3.2mm pilot holes on the cabinetry and
secure the Top Trim to the cabinetry using two
screws each on left and right ends.
2x4H
i. Attach both the side trims back to the unit
Bottom trim install
Single installation only
Attach the insert bottom trim to the slot on the
non-hinge side using screw 10H.
10H
Single and dual Installations
Open doors and align the bottom trim between the clips
and push to clip it in place.
Figure 26
Figure 30
Figure 31
Figure 32
Figure 29
Figure 28
Figure 27
Loading ...
Loading ...
Loading ...