Loading ...
Loading ...
Loading ...
16
MINIMUM BURNER SETTING ADJUSTMENT
Check whether the ame spreads to all burner ports when the burner is lit with the gas
tap set to the minimum position. If some ports do not light, increase the minimum gas rate
setting.
Check whether the burner remains lit even when the gas tap is turned quickly from the
maximum to the minimum position. If the burner does not remain lit, increase the minimum
gas rate setting.
The procedure for adjusting the minimum gas rate setting is described below.
■ Using a screwdriver turn screw “A” until the ame setting is correct (g. 6).
■ Dual burner, model DEGHBG90 only: For the dual burner set the minimum (as
indicated above) for both the gas valves (one for the inner and one for the outer
crown). The operations must be carried out one gas valve at a time.
Normally for ULPG fully tighten the adjustment screw.
LUBRICATING THE GAS TAP
If a gas tap is dicult to turn, disassemble it, clean it carefully with petrol and spread a little
high-temperature-resistant grease on it.
These operations must be performed by an Authorized person/Service agent.
Note: Servicing of this appliance is only to be carried out by Authorised Person.
A
Figure 6
Loading ...
Loading ...
Loading ...